Allied Telesis SwitchBlade x3100 Series - Page 104

Introduction Configuring SNTP
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-74
The following procedure shows the commands used for deleting an SNTP server.
Verify that the UTC offset changed
8
SHOW SYSTEM TIME FULL
--- System Time ---
Date.................................... 2009-12-07
Time.................................... 13:21:55 (STANDARD)
Current UTC Offset................. -01:00:00
Day Light Saving
Status................................ OFF
Timezone.............................. CUSTOM
Start................................. -
End................................... -
DST UTC Offset........................ +00:00:00
Standard UTC Offset................ -01:00:00 <- HERE
SNTP Settings
Status................................ ON
TABLE 1-11 Configuration Procedure for SNTP - Deleting SNTP Server
Step Command Description (Optional)
Review the SNTP settings
1
SHOW SNTP
--------------------------------------------------------------------
SNTP Configuration
--------------------------------------------------------------------
Status On
Local IP 10.52.70.14
Last Update 2009-12-07 09:18:46
Last Delta +00.12s
Last Status Operation Successful
SNTP Server
--------------------------------------------------------------------
192.43.244.18
SNTP Statistics
--------------------------------------------------------------------
Requests Sent 1
Responses Received 1
Disable the SNTP
2
DISABLE SNTP Deactivates the SNTP so that the SBx3112 will no
longer synchronize its clock with the SNTP clock.
Delete the SNTP server
TABLE 1-10 Configuration Procedure for SNTP
Step Command Description (Optional)