Configuring LAG Introduction
4-35
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
ADD LAG INTERFACE
Syntax
ADD LAG=lagname
INTERFACE={ type:id-range | id-range | ifname-list }
Description This command adds interfaces to a Link Aggregation Group (LAG). The LAG must
already exist before interfaces are assigned to it (see CREATE LAG).
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example add lag=sfp interface=3.0
Option Description Default Value
LAG The lagname already created. N/A
INTERFACE The XE or GE interfaces that will be included in the
LAG. These can be added
individually or as a comma-
separated id-ranges or as a forward-slash sepa-
rated type:id-ranges.
All interfaces in a LAG must have the same provi-
sioning
. Refer to Configuration Guidelines.
N/A
To Next Page
Loading...
Need help?
General
