Introduction EPSR and (R)STP Interaction
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4-150
ADD EPSR INTERFACE
Description Adds an Interface to the already existing EPSR domain. Only one interface can be speci-
fied at a time when the EPSR domain is of 'Master' node type. If it's a 'Transit' node type
then the user can specify two interfaces at a time. (More than two interfaces are not
allowed in any case.)
Syntax
ADD EPSR=epsrdomain
INTERFACE={ type:id-range | id-range | ifname-list }
[ TYPE={ PRIMARY | SECONDARY } ]
[ PRIORITY=0..127 ]
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example
ADD EPSR=allied-1 INTERFACE=ETH:[8.2]
Option Description Default Value
EPSR The domain name of the EPSR.
INTERFACE The Ethernet interface that is being configured as
part of the EPSR.
NA
TYPE For a system that is being designated as the Master
Node, whether the interface will be a PRIMARY
PORT (PP) or Secondary port (SP)
SECONDARY
PRIORITY Sets the ring port priority for a domain when the
ring port is part of a common link spanning one or
more superloop segments. Refer to 4.6.10.
0
To Next Page
Loading...
