Introduction EPSR and (R)STP Interaction
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4-152
ADD TRACE EPSR MESSAGETYPE
Description Add an EPSR trace to an interface. Detailed call events pertaining to a port or set of
ports can be obtained by defining and enabling trace log criteria.
Syntax
ADD TRACE EPSR [ ={ epsrdomain-list | ALL } ]
MESSAGETYPE={ HEALTH | RINGUPFLUSH | RINGDOWNFLUSH | LINKDOWN |
LINKFORWARDREQUEST | PERMISSIONLINKFORWARD | QUERYLINKSTATUS | ALL
}
[ INTERFACE={ type:id-range | id-range | ifname-list | ALL } ]
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example ADD TRACE EPSR NC MESSAGETYPE HEALTH
Option Description Default Value
EPSR The name(s) that has been given to the EPSR
domain(s)
NA
MESSAGETYPE The EPSR message types ALL
INTERFACE The interfaces where the TRACE will occur
To Next Page
Loading...
Need help?
General
