Introduction Configuring the Ingress Metering
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
6-58
SHOW TRAFFICDESCRIPTOR
Syntax
SHOW TRAFFICDESCRIPTOR[={tdname-list|ALL}]
Description Shows information about the specified TRAFFICDESCRIPTORs. This includes any classi-
fiers that are associated with the TRAFFICDESCRIPTORs. To see which interfaces are
associated with the TRAFFICDESCRIPTORs, you may use SHOW CLASSIFIER to show
ports associated with the associated classifiers. See the CREATE TRAFFICDESCRIPTOR
command for help on the use of TRAFFICDESCRIPTORs.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SHOW TRAFFICDESCRIPTOR
--- Traffic Descriptor Configuration Data -------------------------
Name Rate Burst Associated Classifiers
(Kbps) (KB)
------------------------ ---------- ----- ------------------------
lim3 128 64 jddipmeter1,jddipmeter2
limit_data 200000 512 qos_data
-------------------------------------------------------------------
Option Description Default Value
TRAFFICDE-
SCRIPTOR
The name(s) of the already created TRAFFICDESCRIP-
TORs, separated by a comma.
To Next Page
Loading...
Need help?
General
