Introduction Password Recovery
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-38
DISABLE USER (SEC)
Syntax
DISABLE USER=login-name
Description Locks out a user. The account is still present, but the user that owns the account is
unable to login. Once disabled, the associated user cannot log into the system again until
his/her access is re-enabled via the ENABLE USER command. The DISABLE USER com-
mand does not, however, log the associated user off the system. If the affected user is
currently logged in, he/she is informed that his/her account was removed, but no other
action is taken. If there is a desire to force the user off the system as part of deleting the
account, the DEACTIVATE SESSION command must also be used.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
DISABLE USER=coleman
Option Description Default Value
USER The login name of the user