Allied Telesis SwitchBlade x3100 Series - Page 865

Configuring BFD Introduction
7-127
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
ADD BFD INTERFACE
Syntax
ADD BFD INTERFACE={ type:id-range | id-range | ifname-list | ALL }
[ INTERVAL=1..60000 ] [ DETECTIONMULTIPLIER=2..255 ]
Description Adds the BFD feature to the selected interfaces.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
ADD BFD INTERFACE=8.18,8.19
Option Description Default Value
INTERFACE The interface where BFD will be added.
INTERVAL Specifies the desired interval in milliseconds between
transmitted packets
200ms
DETEC-
TIONMULTI-
PLIER
The number of consecutive missed packets required to
declare a failure.
3