Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.4.6 Unplugging electrical connector on cool‐
ant temperature sender - G62- - vehicles
with 6.0 ltr. MPI engine
Procedure
• Engine removed ⇒ Rep. gr. 10 .
– Unplug electrical connector -3- on coolant temperature sender
- G62- using assembly tool - T10118- .
Note
Disregard -items 1, 2, 4-.
1.4.7 Unplugging electrical connector on cool‐
ant temperature sender - G62- - vehicles
with 3.0 ltr. TDI engine
Procedure
– Carefully pull engine cover panel off four retaining pins one
after the other -arrows-.
– Unplug electrical connector -1- at air mass meter - G70- .
– Remove air intake hose. To do so, release hose clip -2- and
clamps -arrows-.
– Unplug electrical connector -1- on coolant temperature sender
- G62- using assembly tool - T10118- .
Note
Disregard -item 2-.
Install in reverse order.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
1. Instrument cluster 93
To Next Page
Loading...
