Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.4.8 Unplugging electrical connector on cool‐
ant temperature sender - G62- - vehicles
with 4.0 ltr. TDI engine
Procedure
– Discharge refrigerant circuit ⇒ Air conditioner with refrigerant
R134a .
– Remove air conditioner compressor ⇒ Rep. gr. 87 .
– Unplug electrical connector -1- on coolant temperature sender
- G62- using assembly tool - T10118- .
Note
Disregard -item 2-.
Installation is carried out in the reverse order; note the following:
– Install air conditioner compressor ⇒ Rep. gr. 87 .
– Charge refrigerant circuit ⇒ Air conditioner with refrigerant
R134a .
1.4.9 Unplugging electrical connector on cool‐
ant temperature sender - G62- - vehicles
with 4.2 ltr. TDI engine
Procedure
– Carefully pull the engine cover panel off the four retaining pins
one after the other -arrows-.
– Unplug electrical connector -2- on coolant temperature sender
- G62- -item 1- using assembly tool - T10118- .
Install in reverse order.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
94 Rep. gr.90 - Gauges, instruments
To Next Page
Loading...
