Audi 2003 A8 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Detach wires -1- and -2- at alternator.
– Use hose clamps -3094- to clamp off coolant hoses.
– Detach coolant hoses -3- and -4- on back of alternator.
– Unscrew bolts -arrows- and detach alternator.
Note
♦ If alternator sticks in bracket, screw bolt back in again down to
the last 2 turns.
♦ Tap carefully on bolt heads with flat side of hammer to release
threaded bushes of alternator mount.
Installing
Installation is carried out in the reverse order; note the following:
– To facilitate positioning of alternator, drive back bushes for
securing bolts slightly.
Note
Stiff alternator mount bushes must be freed; otherwise the clamp‐
ing force of the bush will not be adequate even when the bolts are
tightened to the correct torque.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
16 Rep. gr.27 - Starter, current supply, CCS

Audi 2003 A8 Specifications

General

Brand	Audi
Model	2003 A8
Category	Automobile
Language	English