Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
During the program, you are prompted to move the calibration unit
for lane change assist -VAS 6350/4- from the left to the right side
of the calibration platform - VAS 6350- .
– Switch off calibration unit for lane change assist -VAS 6350/4-
and move calibration unit to the other side.
• Voltage supply must be connected to bottom left of calibration
unit for lane change assist (in direction of travel)
Dimension -a- (measured between top edge of calibration unit
and ground).
Lane change assist 1.0 Lane change assist 1.5
Setting dimension in mm
Dimension -a-
800 770
– Pointer at base of calibration unit for lane change assist -VAS
6350/4- must align with setting dimension on graduated scale
-1- at measuring field -arrow-.
Lane change assist 1.0 Lane change assist 1.5
Setting dimension (right-side)
read
off in mm from measuring scale
-1-
679 790
– Switch on calibration unit for lane change assist -VAS 6350/4-
with power switch -3-.
• The green LED -1- must light up.
– Continue to follow the instructions on the display of the vehicle
diagnostic tester.
– After completing calibration of lane change assist, end “Cali‐
bration”, switch off ignition and unplug diagnostic connector.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
328 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
