Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Switch on linear laser - VAS 6350/3- on calibration unit - VAS
6350- .
– Put on “laser protection goggles”.
– Align calibration unit - VAS 6350- so that beam from linear
laser - VAS 6350/3- hits centre of Audi rings on rear lid.
– Check distance (left and right) between locating brackets of
calibration unit - VAS 6350- and measuring paddles -1- on
wheel mountings.
• Specification: 1,700 ± 2 mm
Calibration procedure
Please adhere to the following rules during the calibration proce‐
dure:
• There must not be any metallic reflectors (e.g. tool trolleys,
metal cabinets) within 2 metres of the calibration unit.
• Vehicle doors must not be opened or closed.
• No-one must sit in vehicle.
• Do not allow any person to walk between vehicle and calibra‐
tion unit for lane change assist -VAS 6350/4- .
Procedure
– Switch on calibration unit for lane change assist -VAS 6350/4-
with power switch -3-.
• The green LED -1- must light up.
Note
If the red LED -2- lights up: check calibration unit for lane change
assist -VAS 6350/4- .
– Continue to follow the instructions on the display of the vehicle
diagnostic tester.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
12. Lane change assist 327
To Next Page
Loading...
