Audi 2003 A8 - Page 336

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Secure calibration unit for lane change assist -VAS 6350/4- to
mounting bracket (rear left) on calibration unit - VAS 6350- .
• Voltage supply must be connected to bottom left of calibration
unit for lane change assist (in direction of travel)
Dimension -a- (measured between top edge of calibration unit
and ground).
Lane change assist 1.0 Lane change assist 1.5
Setting dimension in mm
Dimension -a-
800 770
– Pointer at base of calibration unit for lane change assist -VAS
6350/4- must align with setting dimension on graduated scale
-1- at measuring field -arrow-.
Lane change assist 1.0 Lane change assist 1.5
Setting dimension (left-side)
read off in mm from measuring
scale -1-
679 790
– Connect calibration unit for lane change assist -VAS 6350/4-
up to voltage supply.
– Align calibration unit - VAS 6350- horizontally by turning plastic
feet.
• Check spirit level on calibration unit - VAS 6350- -arrow-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
326 Rep. gr.96 - Lights, bulbs, switches - interior