Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Hose clip pliers - VAS 6362-
♦ Drip tray for workshop hoist - VAS 6208-
Removing
– With ignition switched off, disconnect earth cable at battery
⇒ page 2 .
– Drain off coolant ⇒ Rep. gr. 19 .
– Move lock carrier to service position ⇒ Rep. gr. 13 .
– Unplug electrical connector -1- for air mass meter - G70- .
– Detach air hose -4- at intake manifold.
– Disengage brackets for electrical connectors -2- and -3- at air
cleaner (top section).
– Unscrew bolts -arrows-.
– Detach right air cleaner (top section).
– Remove air duct -1-.
– Unscrew bolts -arrows-.
– Take out right air cleaner (bottom section).
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Removing and installing alternator 27
To Next Page
Loading...
