Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
Place a cloth beneath the separating point to catch draining cool‐
ant.
– Detach coolant hose -arrow- at right on engine.
– First carefully pull up engine cover panel at rear and in the
centre -arrows 1-.
– Then pull the engine cover panel forwards off the intake mani‐
fold -arrows 2-.
– To slacken the poly V-belt, apply pressure to tensioner in di‐
rection of the -arrow- using a 30 mm ring spanner.
– Remove poly V-belt from alternator pulley.
– Release pressure from tensioner.
– Place drip tray for workshop hoist - VAS 6208- beneath en‐
gine.
– Detach coolant hose (front) at auxiliary radiator -arrow- and
allow coolant to drain off.
– Remove bolts -1- and -2-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
28 Rep. gr.27 - Starter, current supply, CCS
To Next Page
Loading...
