Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Detach coolant hoses -arrows-.
– Remove bolts -1- and -2-.
– Remove the auxiliary radiator.
– Unscrew electrical wire -1- at alternator.
– Unplug electrical connector -2-.
– Unscrew bolts -arrows-.
Note
♦
If alternator sticks in bracket, screw bolt back in again down to
the last 2 turns.
♦
Tap carefully on bolt heads with flat side of hammer to release
threaded bushes of alternator mount.
– Pivot the alternator slightly down to left.
Note
A 2nd mechanic is required for the remaining procedures for re‐
moving the alternator.
Caution
Coolant will drain out.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Removing and installing alternator 29
To Next Page
Loading...
