Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unclip electrical connectors -1- and -2- from braces.
– Unscrew bolts -arrows-.
– Remove bumper with braces.
WARNING
Do not open refrigerant circuit of air conditioner.
Note
To prevent damage to air conditioner compressor and refrigerant
pipes/hoses, take care to avoid straining, kinking or bending pipes
and hoses.
– Unscrew bolts -arrows-.
– Swivel down condenser with cooler for power steering.
– Tie up condenser at bottom to engine.
– Unplug electrical connector -arrow- on crash sensor for front
airbag (left and right).
– Move all wiring clear at rear of lock carrier.
– Unscrew one nut -1- and one bolt -2- each for lock carrier in
left and right wheel housing.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Removing and installing alternator 41
To Next Page
Loading...
