Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Attach shackles - 10 - 222 A /12- to rear engine lifting eyes.
– Engage shackles - 10 - 222 A /12- on spindles of support bar
- 10 - 222 A- .
– Take up weight of engine slightly with spindles of support
bracket.
– On vehicles with auxiliary heater, unscrew bolts -arrows- for
exhaust pipe of auxiliary/supplementary heater at noise insu‐
lation.
– Unfasten bolts/quick-release fasteners -1- and -2- and detach
noise insulation (front).
– Remove front wheel (right-side).
– Remove front right wheel housing liner ⇒ Rep. gr. 66 .
– Unscrew bolts -1 … 3- on both sides.
– Lower cross member.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
5. Removing and installing starter 65