Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pull off rubber seal -1- for plenum chamber covers.
– Detach plenum chamber covers -2- and -3-.
– Remove rear bolts -3- for body brace.
– Attach adapters - 10 - 222 A /21- without cross beam to sus‐
pension turrets.
• Supports are marked for left and right side of vehicle.
• Centre resting point -2- of supports is positioned on front bolts
for body brace.
• Adapters - 10 - 222 A /21- are secured with rear bolts -3- for
body brace.
• Knurled screw -1- must be screwed down so that support plate
rests on suspension strut turret.
– Fit cross beam with two adapters -T40093/6- to adapters - 10
- 222 A /21- .
– Attach spindles - 10 - 222 A /11- to rear engine lifting eyes.
– Take up weight of engine slightly with spindles of support
bracket.
– Remove the front right wheel.
– Release fasteners -1-, -2- and -4- and remove noise insulation.
– Remove front section of front right wheel housing liner ⇒ Rep.
gr. 66 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
5. Removing and installing starter 69
To Next Page
Loading...
