Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug electrical connector -arrow- at engine mounting (right-
side).
– Unscrew bolts -1 ... 6-.
– Remove engine support with engine mounting.
– Unscrew earth wire -4- at starter.
– Detach electrical wires -2- and -3- at starter.
– Unscrew bolts -1- and -5- and remove starter.
Installing
Installation is carried out in the reverse order; note the following:
Note
♦
Refit all cable ties at the same locations when reinstalling.
♦
Secure all hose connections with the correct type of hose clips
(same as original equipment) ⇒ Electronic parts catalogue .
♦
Renew O-ring.
– Install engine ⇒ Rep. gr. 10 .
– Connect battery. Steps required ⇒ page 3 .
Tightening torques
Component Nm
Starter M10
65
1)
to engine
M12
45
2)
Earth cable to starter 20
Terminal B+ to starter 16
Engine support to cylinder block 40
Engine support to engine mounting 40
Coolant line to engine oil cooler 10
•
1)
Bolt strength rating 10.9.
•
2)
Screwed into intermediate plate.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
76 Rep. gr.27 - Starter, current supply, CCS
To Next Page
Loading...
