Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Assembly tool - T10118-
Preparations
– Unplug electrical connector at coolant temperature sender -
G62- :
♦ Vehicles with 3.0 ltr. MPI engine ⇒ page 88 .
♦ Vehicles with 2.8 ltr. and 3.2 ltr. FSI engine ⇒ page 89
♦ Vehicles with 3.7 ltr. and 4.2 ltr. MPI engine ⇒ page 90 .
♦ Vehicles with 4.2 ltr. FSI engine ⇒ page 90 .
♦ Vehicles with 5.2 ltr. FSI engine ⇒ page 91 .
♦ Vehicles with 6.0 ltr. MPI engine ⇒ page 93 .
♦ Vehicles with 3.0 ltr. TDI engine ⇒ page 93 .
♦ Vehicles with 4.0 ltr. TDI engine ⇒ page 94 .
♦ Vehicles with 4.2 ltr. TDI engine ⇒ page 94 .
Pin assignment for 2-pin connector at coolant temperature sender
- G62-
1 - Sender earth
2 - Wiring connection from coolant temperature sender - G62-
to engine control unit
1.4.1 Unplugging electrical connector on cool‐
ant temperature sender - G62- - vehicles
with 3.0 ltr. MPI engine
Procedure
– Pull off engine cover (rear) -arrows-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
88 Rep. gr.90 - Gauges, instruments
To Next Page
Loading...
