Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unscrew bolts for solenoid valve retaining plate -3- -arrows-.
– Pull off air intake hose -1- at air mass meter - G70- .
– Pull off hose -4- at air duct -2-.
– Unscrew bolt -arrow- and pull off air duct -2- at throttle valve
module - J338- .
– If fitted, pull off hose -1- at air duct.
Note
For illustration purposes the air duct is shown from the rear with
the engine removed.
– Unplug electrical connector -2- on coolant temperature sender
- G62- using assembly tool - T10118- .
Note
Disregard -item 1-.
Install in reverse order.
1.4.2 Unplugging electrical connector on cool‐
ant temperature sender - G62- - vehicles
with 2.8 ltr. and 3.2 ltr. FSI engine
Procedure
– Pull off engine cover (front) -arrows-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
1. Instrument cluster 89
To Next Page
Loading...
