Chery QQ - Page 133

Chery QQ Service Manual Transmission System
-30-
The Standard Value Maintenance input shaft bearing
Disassemble the
input shaft
Measure depressed depth
of rivet
1. 5mm
0.06in
0.5mm
0.02in
Pressure plate assembly:
1.Check if the diaphragm spring has been frayed abnormally or damaged.
2.Check if the Pressure plate has been frayed or if there is overheat point on it.
3.If appears abnormal status, please replace the Pressure plate assembly.
The Pressure plate assembly is not allowed to be dissembled into diaphragm spring
Pressure plate.
Flywheel:
Check if the flywheel surface has been frayed or if there is overheat point on it, if
necessary please repair or replace.
Installation
Attention: Before assembling, check the flywheel surface and platens.
1. Whether surface is clean and dry
2.Install the flywheel on the crankshaft, fix the input shaft bearing on the flywheel.
N.m Kg-m 1b-ft
Tighten the torque bolt
Install the flywheel
Flywheel bolt
Tighten torque
57-65 5.7-6.5 41.5-47.0
Install the input shaft bearing.
3.Aim the clutch disc assembly at the center of flywheel, fix the pressure plate
assembly and bolt, tighten the bolt.
Attention:
Use hand and special tool to press the clutch disc assembly. Tighten the clutch pressure
palte assembly bolt，according to diagonal ingravescence tighten clutch pressure plate
assembly bolt。
N.m Kg-m 1b-ft
Clutch pressure
palte assembly bolt
torque
18-28 1.8-2.8 13.5-20.0
Chery Automobile Co., Ltd