Chery QQ Service Manual Transmission System
1- Snap ring
2-
Synchronizer insert
3- Hub
4- Hub sleeve outer race
Notice:
Synchronizer insert is not on the right direction.
Snap ring and synchronizer insert and synchronizer assembly, 5th
synchronizer assembly compare is big.
5.Install the output shaft bearing.
1-Output shaft right
bearing
2- Output shaft
3- Special tool
Fig.3-38
6.Spread lubricant on the needle roller bearing, and then install the 1st driven gear
and 1st synchronizer ring.
1-1st synchronizer ring
2-2nd synchronizer ring
Fig.3-39
Notice: The width of 1st synchronizer ring synchronizer insert is smaller than the
width of the 2nd synchronizer ring synchronizer insert.
Width：“b” ：8.2mm
“c” ：8.8mm
-71-
The width of the 1st and 2nd needle roller bearing is the same.
Chery Automobile Co., Ltd
To Next Page
Loading...
