Chery QQ - Page 488

Chery QQ Service Manual
1. Installation of Windshield
（1）No touch on windshield surface
bonding agent
after cleaning
(2) Cut roughness off bonding agent sticking
to car body with knife
Note：Keep bonding agent on car body
as much as possible
（3）Clean the cutting surface of
bonding agent with a rag soaked in cleaning liquid
Note：Even though all of bonding agent is completely removed, car body surface must
be cleaned
stop
2. Remove block stop：
Remove block stop with knife
3. Clean the removed windshield
（1）Remove the bonding agent stuck
on windshield with scraper
（2）Clean windshield with cleaning
liquid
Attention：Do not touch windshield
after cleaning
4. Replace clamps if necessary
（1）Remove stops with knife
（2）Take down used clamps
（3）Put new clamps on
- 260 – Chery Automobile Co.,Ltd