Contents
xv
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Recommended Values for Traffic Marking 7-21
Configuring Traffic Marking 7-22
Configuring IP Precedence Marking 7-22
Configuration Examples for IP Precedence Marking and Classification 7-23
Configuring IP DSCP Marking 7-24
Configuration Examples for IP DSCP Marking and Classification 7-25
Configuring Class of Service Marking 7-26
Configuration Examples for CoS Marking and Classification 7-27
Configuring QoS Group Marking 7-28
Configuration Examples for Configuring QoS Group Marking and Classification 7-28
Setting the ATM Cell Loss Priority Bit 7-29
Configuration Example for Setting the ATM CLP Bit 7-30
Configuring MPLS Experimental Marking 7-31
Configuration Examples for Configuring MPLS Experimental Marking and Classification 7-32
Configuring Discard-Class Marking 7-33
Configuration Examples for Configuring Discard-Class Marking and Classification 7-34
Configuring Tunnel Header Marking Using the set Command 7-35
Configuration Example for Tunnel Header Marking Using the set Command 7-35
Configuring Tunnel Header Marking Using the police Command 7-36
Example Configuration for Tunnel Header Marking Using the police Command 7-36
Verifying Traffic Marking 7-37
Verification Examples for Traffic Marking 7-38
Related Documentation 7-39
CHAPTER
8 Prioritizing Services 8-1
Low-Latency Priority Queuing 8-1
Feature History for Low-Latency Priority Queuing 8-2
Bandwidth Starvation 8-3
Multi-Level Priority Queues 8-3
Feature History for Multi-Level Priority Queues 8-4
Child Service Policy Allowed Under Priority Class 8-4
Interfaces Supporting Priority Queuing 8-4
Queues per Policy Map 8-5
Restrictions and Limitations for Priority Queuing 8-5
Restrictions for Multi-Level Priority Queues 8-5
Configuring a Priority Queue 8-6
Configuring Multi-Level Priority Queues 8-7
Configuration Examples for Configuring Priority Queues 8-9
To Next Page
Loading...
