Cisco ASR 1000 Series

Verifying Scramble Configuration 249
Saving the Configuration 250
Verifying the Interface Configuration 250
Verifying Per-Port Interface Status 250
Configuration Examples 251
DSU Configuration Example 252
MDL Configuration Example 252
Encapsulation Configuration Example 252
Framing in Unchannelized Mode Configuration Example 253
Facility Data Link Configuration Example 253
Scrambling Configuration Example 253
Creating a Multilink Bundle Configuration Example 253
Assigning a T1 Interface to a Multilink Bundle Configuration Example 254
CHAPTER 17 Configuring the 2-Port and 4-Port T3/E3 Serial SPA 255
Configuration Tasks 255
Required Configuration Tasks 255
Setting the Card Type 256
Setting the IP Address 256
Verifying Controller Configuration 257
Verifying the Interface Configuration 258
Specifying the Interface Address on a SPA 259
Optional Configurations 259
Configuring Data Service Unit Mode 259
Verifying DSU Mode 261
Configuring Maintenance Data Link 261
Verifying MDL 264
Configuring Scramble 264
Verifying Scramble Configuration 265
Configuring Framing 265
Verifying Framing Configuration 266
Configuring Encapsulation 267
Verifying Encapsulation 267
Configuring Cable Length 268
Verifying Cable Length Setting 268
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
xiv OL-14127-17
Contents