Cisco ASR 1000 Series

HA State : DSP_HA_STATE_PENDING1
Max signal/voice channel: 43/43
Max credits: 645
num_of_sig_chnls_allocated: 43
Transcoding channels allocated: 43
Group: FLEX_GROUP_XCODE, complexity: LOW
Shared credits: 0, reserved credits: 645
Transcoding channels allocated: 24
Credits used (rounded-up): 360
Configuring the RTCP on the SPA-DSP
This section provides details of the procedure to enable the generation and termination of the RTCP on the
SPA-DSP. From the Cisco IOS XE Release 3.4.0S onwards, the SPA-DSP can terminate and generate the
RTCP data.
Configuring the RTCP on the SPA-DSP on the Cisco Unified Border Element
for the Unified Model
To configure the RTCP on the SPA-DSP on the Cisco Unified Border Element: Unified Model, perform the
following steps:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
sbc sbc-name
4.
rtcp-regenerate
DETAILED STEPS
PurposeCommand or Action
Enables the privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Router> enable
Step 1
Enters the global configuration (config) mode.configure terminal
Example:
Router# configure terminal
Step 2
Creates an SBC service on the Cisco Unified Border Element
and enters into the SBC configuration mode.
sbc sbc-name
Example:
Router(config)# sbc mySBC
Step 3
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 413
Configuring the Cisco DSP SPA for the ASR 1000 Series Aggregation Services Routers
Configuring the RTCP on the SPA-DSP