Cisco ASR 1000 Series Software Configuration Guide

PurposeCommand or Action
Example:
codec g711ulaw
Example:
codec g711alaw
Example:
codec g729ar8
Example:
codec g729abr8
Example:
maximum sessions 588
Example:
associate application SBC
Example:
vad on override
Example:
!
Change in Command Output During Call Recovery
In Cisco IOS XE Release 3.3.0s, the show voice dsp group all command output that is displayed when a
SPA-DSP undergoes call recovery is enhanced. The command output is seen only during the call recovery
process, which lasts for a few milliseconds. The additional information that is included in the command output
pertains to: HA State : DSP_HA_STATE_PENDING1. The additional information is displayed when a
SPA-DSP undergoes call recovery.
The following sample output shows how HA State: DSP_HA_STATE_PENDING1 is added. The additional
command output is seen only in Cisco IOS XE Release 3.3.0S and later releases:
Router# show voice dsp group all
Show DSP group all
DSP groups on slot 0 bay 0:
dsp 1:
State: UP
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
412 OL-14127-17
Configuring the Cisco DSP SPA for the ASR 1000 Series Aggregation Services Routers
Change in Command Output During Call Recovery

Cisco ASR 1000 Series Specifications

General

Series	ASR 1000
Category	Network Router
Operating System	Cisco IOS XE
Memory	Up to 64 GB
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC options
Dimensions	Varies by model
Encryption	IPsec, SSL
Storage	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model