Cisco ASR 1000 Series Software Configuration Guide

CHAPTER 16
Configuring the 2-Port and 4-Port Channelized
T3 SPAs
This chapter provides information about configuring the 2-Port and 4-Port Channelized T3 SPAs on the
Cisco ASR 1000 Series Routers.
•
Configuration Tasks, page 237
•
Verifying the Interface Configuration, page 250
•
Configuration Examples, page 251
Configuration Tasks
This section describes how to configure the 2-Port and 4-Port Channelized T3 SPA for the Cisco ASR 1000
Series Routers and verify the configuration. For information about managing your system images and
configuration files, refer to the following:
•
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
•
Cisco IOS Configuration Fundamentals Configuration Guide
•
Cisco IOS Configuration Fundamentals Command Reference
Required Configuration Tasks
This section lists the required configuration steps to configure the 2-Port and 4-Port Channelized T3 SPA.
Some of the required configuration commands implement default values that might be appropriate for your
network.
To better understand the address format used to specify the physical location of the SIP, SPA, and interfaces,
see the Specifying the Interface Address on a SPA, on page 242.
Note
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 237

Cisco ASR 1000 Series Specifications

General

Series	ASR 1000
Category	Network Router
Operating System	Cisco IOS XE
Memory	Up to 64 GB
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC options
Dimensions	Varies by model
Encryption	IPsec, SSL
Storage	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model