Cisco ASR 1000 Series

PurposeCommand or Action
Example:
Alarm reporting enabled for: SF SWLOF B1-TCA B2-TCA PLOP
WLOS
Example:
Example:
Rx(K1/K2): 00/00 Tx(K1/K2): 00/00
Example:
S1S0 = 00, C2 = 0x1A
Example:
PATH TRACE BUFFER: UNSTABLE
Example:
Remote J1 Byte :
Example:
Example:
BER thresholds: SD = 10e-6 SF = 10e-3
Example:
TCA thresholds: B1 = 10e-6 B2 = 10e-6 B3 = 10e-6
Enters the global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Configures the LAN PHY mode for the 1-Port
10-Gigabit Ethernet LAN/WAN PHY SPA.
hw-module subslot slot/subslot enable LAN
Example:
Router(config)# hw-module subslot 0/1 enable LAN
Step 3
Whenever mode is changed from WAN
mode to LAN mode
Note
Example:
Example:
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 153
Configuring the Ethernet SPAs
Configuring the LAN-PHY Mode