•
It supports 40 Gbps of non oversubscribed throughput.
•
Compatible with existing and future SPAs, ESPs, and RPs.
•
It supports online-insertion-and-removal (OIR) of all SIP-10 SPAs and Cisco ASR1000-SIP40.
•
Provides higher port density support of 48 point dual priority, and 96 point single priority.
•
Enables enhanced QoS and timestamp support.
•
Performs ingress packet prioritization based on Layer 2 or Layer 3 headers.
•
Enables the flow-control the SPAs.
•
Distributes line clocking reference from a single SPA to the RPs.
•
It supports Onboard Failure Logging (OBFL).
•
All the SPAs on Cisco ASR1000-SIP40 provide FPD support.
•
From Release 3.7.0S onward, the Cisco ASR1000-SIP40 is supported on all the routers that support the
Cisco ASR1000-SIP10.
The Cisco ASR1000-SIP40 supports four half-height SPAs, two full-height SPAs, and a combination of
two half-height and one full-height SPAs. The Cisco ASR1000-SIP40 does not support double-wide SPAs,
double-high SPAs having two connectors.
Note
Cisco ASR1000-SIP10 High-Availability Features
•
Online insertion and removal (OIR) of the SIP and SPAs
•
Nonstop Forwarding (NSF)
•
Stateful switchover (SSO)
•
Frame Relay switching
•
VC bundle Class of Service (CoS) precedence mapping
Supported MIBS
The following MIBs are supported in Cisco IOS XE Release 2.2 and later releases for the Cisco ASR1000-SIP10
on a Cisco ASR 1000 Series Router:
•
ENTITY-MIB (RFC 4133)
•
CISCO-ENTITY-FRU-CONTROL-MIB
•
CISCO-ENTITY-ALARM-MIB
•
ENTITY-SENSOR-MIB (RFC 3433)
•
CISCO-ENTITY-SENSOR-MIB
•
CISCO-EXTENDED-EXT-MIB
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 29
Overview of the SIP
Supported MIBS
To Next Page
Loading...
Need help?
General
