Cisco ASR 1000 Series

Supported MIBs
The following MIBs are supported in Cisco IOS XE Release 2.4 for the Cisco WebEx Node SPA on the Cisco
ASR 1000 Series Routerss:
Common MIBs
•
ENTITY-MIB
•
IF-MIB
•
MIB-II
Cisco-Specific Common MIBs
•
CISCO-ENTITY-EXT-MIB
•
OLD-CISCO-CHASSIS-MIB
•
CISCO-ENTITY-FRU-CONTROL-MIB
•
CISCO-ENTITY-ASSET-MIB
•
CISCO-ENTITY-SENSOR-MIB
•
CISCO-ENTITY-VENDORTYPE-OID-MIB
For more information about MIB support on a Cisco ASR 1000 Series Routers, refer to the Cisco ASR 1000
Series Aggregation Services Routers MIB Specifications Guide , at:
http://www.cisco.com/en/US/docs/routers/asr1000/mib/guide/asr1kmib.html
To locate and download MIBs for the selected platforms, Cisco IOS releases, and feature sets, use the Cisco
MIB Locator found at:
http://tools.cisco.com/ITDIT/MIBS/servlet/index
If the Cisco MIB Locator does not support the MIB information that you need, you can also obtain a list of
supported MIBs and download the MIBs from the Cisco MIBs page at:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
To the access Cisco MIB Locator, you must have an account on Cisco.com. If you have forgotten or lost your
account information, send a blank e-mail to cco-locksmith@cisco.com . An automatic check will verify that
your e-mail address is registered with Cisco.com. If the check is successful, account details with a new random
password will be e-mailed to you. Qualified users can establish an account on Cisco.com by following the
directions found at:
https://tools.cisco.com/RPF/register/register.do
Displaying the SPA Hardware Type
To verify the SPA hardware type that is installed in your Cisco ASR 1000 Series Routers, use the show
interfaces service-engine command or the show hw-module subslot service-engine status command.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
350 OL-14127-17
Overview of the Cisco WebEx Node for the Cisco ASR 1000 Series Routers
Supported MIBs