Cisco ASR 1000 Series Software Configuration Guide

CHAPTER 22
Configuring the Cisco WebEx Node for the ASR
1000 Series Aggregation Services Routers
This chapter provides information about configuring the Cisco WebEx Node for ASR 1000 Series on the
Cisco ASR 1000 Series Aggregation Services Routers, also referred to in this document as the Cisco WebEx
Node SPA.
•
Prerequisites, page 353
•
Configuration Tasks, page 357
•
Verifying the Service Engine Configuration, page 362
•
Configuration Examples, page 380
Prerequisites
Complete the following prerequisites to successfully activate your Cisco WebEx Node for ASR 1000 Series:
Registering with the WebEx Data Center and the Cisco WebEx Node
Management System
To successfully activate a Cisco WebEx Node for ASR 1000 Series, certain registration and provisioning
activities must be performed with the WebEx Data Center using the Cisco WebEx Node Management System.
The Cisco WebEx Node Management System also provides monitoring and reporting for Cisco WebEx nodes.
Once the SPA is registered with the WebEx Data Center, certain node security information must be gathered
and then configured on the Cisco WebEx Node for ASR 1000 Series.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 353

Cisco ASR 1000 Series Specifications

General

Series	ASR 1000
Category	Network Router
Operating System	Cisco IOS XE
Memory	Up to 64 GB
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC options
Dimensions	Varies by model
Encryption	IPsec, SSL
Storage	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model