Cisco ASR 1000 Series Software Configuration Guide

Example:
show version running
Step 12
Check whether the ROMMON version in WebEx SPA is up-to-date by using the show platform command. If it is not,
use the upgrade rommon all command to update the ROMMON version.
Step 13
Deploy the WebEx SPA package:
Example:
request platform software package install rp rp-slot-number file
bootflash:asr1000rp2-sipspawmak9.03.08.02.S.153-1.S2.pkg
Here, rp-slot-number is active-rp-slot-number.
For a dual RP system, perform this additional step:
Example:
request platform software package install rp stby-rp-slot-number file
stby-bootflash: asr1000rp2-sipspawmak9.03.08.02.S.153-1.S2.pkg
Step 14
Verify that the SPA is active:
Example:
show platform
Step 15
Go to https://wma.webex.com and log in.
Step 16
Choose Administration > Node management
Step 17
Select all the individual node names.
Step 18
Copy the wma-passcode string to all the nodes, for example, mtg_webex-web d2bc97983456676fbb7ea5cfcc2c3a57
Step 19
Enter the configuration mode:
Example:
configure terminal
Step 20
Enter the individual SPA interfaces, and re-enter the wma-passcodes:
Example:
interface service-Engine 0/0/0
ip address <ip addr> <subnet mask>
shutdown
service-engine ip address <ip addr> <subnet mask>
service-engine default-gateway <ip addr>
servicepengine wma-passcode <wma-token>
service-engine nameserver <primary DNS nameserver> <secondary DNS nameserver>
service-engine hostname <spa name> <domainname>
service-engine wma-url <webex url for wma spa config>
no shutdown
show hw-module subslot <subslot> service-engine status
Repeat Step 19 for all the interfaces.
Step 21
Write configuration to memory:
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 375
Configuring the Cisco WebEx Node for the ASR 1000 Series Aggregation Services Routers
Configuring the WebEx Node

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English