Cisco ASR 1000 Series Software Configuration Guide

•
Alarms cannot be suppressed in unframed CEM mode (SAToP). Alarms received from the remote
SAToP peer across the PSN will always be propagated over the attachment circuit.
•
The forward-alarm {ais/rai} is a hidden command and is not available in the option list. You must
type the full command.
Verifying the Interface Configuration
The show cem circuit command shows information about the circuit state, administrative state, the CEM ID
of the circuit, and the interface on which it is configured. If xconnect is configured under the circuit, the
command output also includes information about the attached circuit.
Router# show cem circuit
?
<0-504> CEM ID
detail Detailed information of cem ckt(s)
interface CEM Interface
summary Display summary of CEM ckts
| Output modifiers
Router# show cem circuit
CEM Int. ID Line Admin Circuit AC
--------------------------------------------------------------
CEM0/1/0 1 UP UP ACTIVE --/--
CEM0/1/0 2 UP UP ACTIVE --/--
CEM0/1/0 3 UP UP ACTIVE --/--
CEM0/1/0 4 UP UP ACTIVE --/--
CEM0/1/0 5 UP UP ACTIVE --/--
The show cem circuit 0-504 command displays the detailed information about that particular circuit.
Router# show cem circuit 1
CEM0/1/0, ID: 1, Line State: UP, Admin State: UP, Ckt State: ACTIVE
Idle Pattern: 0xFF, Idle cas: 0x8, Dummy Pattern: 0xFF
Dejitter: 5, Payload Size: 40
Framing: Framed, (DS0 channels: 1-5)
Channel speed: 56
CEM Defects Set
Excessive Pkt Loss RatePacket Loss
Signalling: No CAS
Ingress Pkts: 25929 Dropped: 0
Egress Pkts: 0 Dropped: 0
CEM Counter Details
Input Errors: 0 Output Errors: 0
Pkts Missing: 25927 Pkts Reordered: 0
Misorder Drops: 0 JitterBuf Underrun: 1
Error Sec: 26 Severly Errored Sec: 26
Unavailable Sec: 5 Failure Counts: 1
Pkts Malformed: 0
The show cem circuit summary command displays the number of circuits which are up or down per interface
basis.
Router# show cem circuit summary
CEM Int. Total Active Inactive
--------------------------------------
CEM0/1/0 5 5 0
The show running configuration command shows detail on each CEM group:
Router# show running configuration
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 543
Configuring the Circuit Emulation over Packet Shared Port Adapter
Verifying the Interface Configuration

Cisco ASR 1000 Series Specifications

General

Series	ASR 1000
Category	Network Router
Operating System	Cisco IOS XE
Memory	Up to 64 GB
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC options
Dimensions	Varies by model
Encryption	IPsec, SSL
Storage	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model