Cisco ASR 1000 Series

PurposeCommand or Action
Example:
end
Configuring the LAN-PHY Mode
This section describes how to configure the LAN-PHY mode on the 1-Port 10GE LAN/WAN-PHY Shared
Port Adapter (SPA-1X10GE-WL-V2).
SUMMARY STEPS
1.
show controllers wanphy 0/1/0
2.
configure terminal
3.
hw-module subslot slot/subslot enable LAN
4.
exit
5.
show controllers wanphy 0/1/0
DETAILED STEPS
PurposeCommand or Action
Displays the configuration mode of the
LAN/WAN-PHY controller. By default, prior to
show controllers wanphy 0/1/0
Example:
Router# show controllers wanphy 0/1/0
Step 1
configuration of the LAN-PHY mode, the
controller operates in the WAN-PHY mode.
Example:
TenGigabitEthernet0/1/0
Example:
Mode of Operation: WAN Mode
Example:
SECTION
Example:
LOF = 0 LOS = 0
BIP(B1) = 0
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 151
Configuring the Ethernet SPAs
Configuring the LAN-PHY Mode