Cisco ASR 1000 Series

example configures interface port 0 (the first port) of the SPA located in subslot 0 of the SIP that is installed
in slot 2 of the Cisco ASR 1000 Series Router:
!Enter global configuration mode
!
Router# configure terminal
!
! Specify the interface address
!
Router(config)# interface pos 2/0/0
!
! Configure an IP address
!
Router(config-if)# ip address 192.168.50.1 192.255.255.0
!
! Enable the interface
!
Router(config-if)# no shutdown
!
! Save the configuration to NVRAM
!
Router(config-if)# exit
Router# copy running-config startup-config
MTU Configuration Example
The following example sets the MTU to 4470 bytes on interface port 1 (the second port) of the SPA located
in the bottom subslot (1) of the SIP that is installed in slot 2 of the Cisco ASR 1000 Series Router:
!Enter global configuration mode
!
Router# configure terminal
!
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
206 OL-14127-17
Configuring the POS SPAs
MTU Configuration Example