Cisco ASR 1000 Series Software Configuration Guide

PurposeCommand
Deactivates the SPA in the specified slot and subslot
of the SIP, where:
• slot-number—Specifies the chassis slot number
where the SIP is installed.
• subslot-number —Specifies the subslot number
on a SIP where a SPA is installed.
• powered—(Optional) Shuts down the SPA and
all of its interfaces, and leaves them in an
administratively down state with power enabled.
This is the default state.
• unpowered—(Optional) Shuts down the SPA
and all of its interfaces, and leaves them in an
administratively down state without power.
Router(config)# hw-module subslot
slot-number/subslot-number shutdown powered |
unpowered
Deactivates the SPA in the specified slot and subslot
of the SIP, where:
• slot-number—Specifies the chassis slot number
where the SIP is installed.
• subslot-number—Specifies the subslot number
on a SIP where a SPA is installed.
• reload—Stops and restarts the specified SPA.
• stop—Stops the specified SPA.
• start—Starts the specified SPA.
Router(config)# hw-module subslot
slot-number/subslot-number {reload | stop | start}
For more information about chassis slot and SIP subslot numbering, refer to the “Identifying Slots and Subslots
for the SIPs and SPAs” section in the Configuring the SIP chapter.
Reactivating a SPA
You do not need to reactivate a SPA after an OIR of either the SIP or a SPA if you did not deactivate the
SPA prior to removal when using the hw-module subslot command in global configuration mode. If the
Cisco ASR 1000 Series Aggregation Services Routers is running, then the SPAs automatically start upon
insertion into the SIP or with insertion of a SIP into the Cisco ASR 1000 Series Aggregation Services
Routers.
Note
If you deactivate a SPA using the hw-module subslot stop command, and need to reactivate it without
performing an OIR, you must use the hw-module subslot start command to reactivate the SPA and its
interfaces.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 43
Troubleshooting the SIP
Preparing for Online Removal of a SPA

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English