Cisco ASR 1000 Series Software Configuration Guide

PurposeCommand
Restarts a disabled interface.Router(config-if)# no shutdown
Verifying the Interface Configuration
Besides using the show running-configuration command to display your Cisco ASR 1000 Series Routers
configuration settings, you can use the show interfaces serial and the show controllers serial commands to
get detailed information on a per-port basis for your 8-Port Channelized T1/E1 Serial SPA.
Verifying Per-Port Interface Status
To find detailed interface information on a per-port basis for the 8-Port Channelized T1/E1 Serial SPA, use
the show interfaces serial command.
Router# show interfaces serial 3/0/1:0
Serial0/3/0:0 is up, line protocol is up
Hardware is SPA-8XCHT1/E1
Internet address is 79.1.1.2/16
MTU 1500 bytes, BW 1984 Kbit, DLY 20000 usec,
reliability 255/255, txload 240/255, rxload 224/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive not set
Last input 3d21h, output 3d21h, output hang never
Last clearing of ''show interface'' counters never
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 2998712
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 1744000 bits/sec, 644 packets/sec
5 minute output rate 1874000 bits/sec, 690 packets/sec
180817311 packets input, 61438815508 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
2 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 2 abort
180845200 packets output, 61438125092 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions no alarm present
Timeslot(s) Used:1-31, subrate: 64Kb/s, transmit delay is 0 flags 2
Using show Commands to Check SFP Module and XFP Module
Status
You can use various show commands to view information specific to SFP, XFP, CWDM, and DWDM optical
transceiver modules.
To check or verify the status of an SFP Module or XFP Module, use the following show commands:
•
show hw-module slot/subslot transceiver port idprom detail
•
show hw-module slot/subslot transceiver port idprom brief
•
show hw-module slot/subslot transceiver port idprom dump
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 133
Configuring the Ethernet SPAs
Verifying the Interface Configuration

Cisco ASR 1000 Series Specifications

General

Series	ASR 1000
Category	Network Router
Operating System	Cisco IOS XE
Memory	Up to 64 GB
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC options
Dimensions	Varies by model
Encryption	IPsec, SSL
Storage	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model