Cisco ASR 1000 Series

PurposeCommand or Action
Exits global-configuration (config) mode and
enters privilege-exec mode.
exit
Example:
Router(config)# exit
Step 4
Displays the configuration mode for the
LAN/WAN-PHY controller. The example shows
show controllers wanphy 0/1/0
Example:
Router# show controllers wanphy 0/1/0
Step 5
the mode of operation as LAN mode for the 1-Port
10-Gigabit Ethernet LAN/WAN PHY SPA.
Example:
TenGigabitEthernet0/1/0
Example:
Mode of Operation: LAN Mode
Configuring the WAN-PHY Mode
This section describes how to configure the WAN-PHY mode on the 1-Port 10GE LAN/WAN-PHY Shared
Port Adapter (SPA-1X10GE-WL-V2). By default, the 1-Port 10-Gigabit Ethernet LAN/WAN PHY SPA
operates in the WAN-PHY mode.
SUMMARY STEPS
1.
show controllers wanphy 0/1/0
2.
configure terminal
3.
hw-module subslot slot/subslot enable WAN
4.
exit
5.
show controllers wanphy 0/1/0
DETAILED STEPS
PurposeCommand or Action
Displays the configuration mode of the
LAN/WAN-PHY controller. The example
show controllers wanphy 0/1/0
Example:
Router# show controllers wanphy 0/1/0
Step 1
indicates that the SPA is running in the
LAN-PHY mode.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
154 OL-14127-17
Configuring the Ethernet SPAs
Configuring the WAN-PHY Mode