Cisco ASR 1000 Series

PurposeCommand or Action
Enables AIS or RAI alarm forwarding on the selected T1 controller
interface for the 2-Port Channelized T3/E3 ATM CEoP SPA.
•
•
Router(config-controller)# t1 1-28
forward-alarm ais/rai
Configuring AIS and RAI Alarm Forwarding for E1 on the CEoP SPA
To enable AIS and RAI forwarding on the SPA-24CHT1-CE-ATM and the SPA-2CHT3-CE-ATM for E1
mode, perform the following procedure:
SUMMARY STEPS
1.
Router> enable
2.
Router# configure terminal
3.
Do one of the following:
•
Router(config)# controller e1 slot/subslot/port
•
•
Router(config)# controller t3 slot/subslot/port
4.
Do one of the following:
•
Router(config-controller)# forward-alarm ais/rai
•
•
Router(config-controller)# e1 1-21 forward-alarm ais/rai
DETAILED STEPS
PurposeCommand or Action
Enables the privileged EXEC mode. Enter your password if
prompted.
Router> enable
Step 1
Enters the global configuration (config) mode.Router# configure terminal
Step 2
Enters the controller configuration mode pertaining to the specified
slot, subslot, and port.
Do one of the following:
Step 3
•
Router(config)# controller e1
slot/subslot/port
or
Selects the controller for the SPA port that is to be configured.
•
•
Router(config)# controller t3 slot/subslot/port
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 539
Configuring the Circuit Emulation over Packet Shared Port Adapter
Configuring AIS and RAI Alarm Forwarding for E1 on the CEoP SPA