Cisco ASR 1000 Series

•
For ATM SPAs on the Cisco ASR1000 Series Aggregation Services Routers, ISSU from releases prior
to Cisco IOS XE Release 2.5.0 to Cisco IOS XE Release 2.5.0, or from Cisco IOS XE Release 2.5.0 to
a release prior to Cisco IOS XE Release 2.5.0, is not supported. If you want to perform ISSU in this
environment, you must first remove the configuration from the ATM SPAs on the router, and then shut
down the SPAs using the shutdown command prior to running the ISSU process.
Supported MIBs
The following MIBs are supported in Cisco IOS XE Release 2.3 and later releases for the ATM SPAs on the
Cisco ASR 1000 Series Routers.
•
ATM-MIB
•
CISCO-AAL5-MIB
•
CISCO-ATM-EXT-MIB
•
CISCO-CLASS-BASED-QOS-MIB
•
CISCO-ENTITY-ALARM-MIB
•
CISCO-ENTITY-EXT-MIB
•
CISCO-ENTITY-FRU-CONTROL-MIB
•
CISCO-ENTITY-ASSET-MIB
•
CISCO-ENTITY-SENSOR-MIB
•
CISCO-IETF-PW-MIB
•
CISCO-IETF-PW-MPLS-MIB
•
CISCO-IF-EXTENSION-MIB
•
CISCO-MQC-MIB
•
CISCO-PPPOE-MIB (beginning in Cisco IOS XE Release 2.5)
•
CISCO-SONET-MIB
•
ENTITY-MIB
•
ENTITY-SENSOR-MIB
•
IF-MIB
•
MIB-II
•
MPLS-CEM-MIB
•
OLD-CISCO-CHASSIS-MIB
•
SONET-MIB
For more information about MIB support on a Cisco ASR 1000 Series Routers, refer to the Cisco ASR 1000
Series Aggregation Services Routers MIB Specifications Guide , at the following URL:
http://www.cisco.com/en/US/docs/routers/asr1000/mib/guide/asr1kmib.html
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 53
Overview of the ATM SPAs
Supported MIBs