Cisco ASR 1000 Series

CHAPTER 18
Configuring the 4-Port Serial Interface SPA
This chapter provides information about configuring the 4-Port Serial Interface SPA on Cisco ASR 1000
Series Routers.
•
Configuration Tasks, page 277
•
Verifying the Interface Configuration, page 287
•
Configuration Examples, page 288
Configuration Tasks
This section describes how to configure the 4-Port Serial Interface SPA for the Cisco ASR 1000 Series Routers
and verify the configuration. For information about managing your system images and configuration files,
refer to the following:
•
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
•
Cisco IOS Configuration Fundamentals Configuration Guide
•
Cisco IOS Configuration Fundamentals Command Reference
Configuring the 4-Port Serial Interface SPA
To configure the 4-Port Serial Interface SPA, complete these steps:
SUMMARY STEPS
1.
Router# configure terminal
2.
Router(config)# interface serial slot/subslot/port
3.
Router(config-if)# ip address address mask
4.
Router(config-if)# clock rate bps
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 277