Cisco ASR 1000 Series

PurposeCommand or Action
Configures the controller framing for SONET framing
(default).
Router(config-controller)# framing sonet
Step 2
Specifies the STS identifier.
Router(config-controller)# sts-1 2
Step 3
Specifies VT-15 as the STS-1 mode of operation.Router(config-ctrlr-sts1)# mode vt-15
Step 4
Creates a virtual tributary group carrying a T1.
Router(config-controller-stsl)# vtg 5 t1 1 cem-group
15 timeslots 1-5,20-23
Step 5
Exits the controller configuration mode.Router(config-controller-sts1)# exit
Step 6
Configuring SDH for AU-4 C-12
To enable an interface under SDH framing with AU-4 mapping after configuring the SONET controller,
perform the following steps:
SUMMARY STEPS
1.
Router(config)# controller sonet 0/1/0
2.
Router(config-controller)# framing sdh
3.
Router(config-controller)# aug mapping au-4
4.
Router(config-controller)# au-4 1 tug-3 2
5.
Router(config-ctrlr-tug3)# mode c-12
6.
Router(config-ctrlr-tug3)# tug-2 1 e1 1 cem-group 1 unframedor
DETAILED STEPS
PurposeCommand or Action
Selects the controller to be configured.
Router(config)# controller sonet 0/1/0
Step 1
Specifies SDH as the framing mode.Router(config-controller)# framing sdh
Step 2
Specifies AUG mapping.Router(config-controller)# aug mapping au-4
Step 3
Selects the AU-4 and TUG-3 to be configured.
Router(config-controller)# au-4 1 tug-3 2
Step 4
Specifies the channelization mode for the TUG-3.Router(config-ctrlr-tug3)# mode c-12
Step 5
Creates a SAToP CEM group.
Router(config-ctrlr-tug3)# tug-2 1 e1 1 cem-group 1
unframedor
Step 6
orCreates a CESoPSN CEM group.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 515
Configuring the Circuit Emulation over Packet Shared Port Adapter
Configuring SDH for AU-4 C-12