Cisco ASR 1000 Series

Verifying a Successful Upgrade
After the upgrade process is complete, you can use the show hw-module all fpd command to verify that the
FPD image has been successfully upgraded:
Router# show hw-module all fpd
==== ====================== ====== =============================================
H/W Field Programmable Current Min. Required
Slot Card Type Ver. Device: "ID-Name" Version Version
==== ====================== ====== ================== =========== ==============
0/0 SPA-4XOC3-POS 1.0 1-I/O FPGA 3.4 3.4
---- ---------------------- ------ ------------------ ----------- --------------
0/1 SPA-4XOC3-POS 1.0 1-I/O FPGA 3.4 3.4
---- ---------------------- ------ ------------------ ----------- --------------
0/2 SPA-1X10GE-L-V2 1.0 1-10GE I/O FPGA 1.9 1.9
---- ---------------------- ------ ------------------ ----------- --------------
0/3 SPA-1X10GE-L-V2 1.0 1-10GE I/O FPGA 1.9 1.9
==== ====================== ====== =============================================
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
430 OL-14127-17
Upgrading Field-Programmable Devices
Verifying a Successful Upgrade