Sample Configurations of the 2-Port Channelized T3/E3 CEoP SPA in the Clear-Channel T3 Mode
Configure the SPA in the T3 mode as follows:
Router(config)# card type T3 5 0
<SPA Reloads itself after the card type is configured. Only after SPA is UP, configure the
controller as T3 or E3>
Router(config)# controller T3 5/0/0
Create a T3 ATM interface as follows:
Router(config-controller)# atm
Create a CEM group as follows:
Router(config-controller)# cem-group 0 unframed
Sample Configurations of the 2-Port Channelized T3/E3 CEoP SPA in the Clear-Channel E3 Mode
Configure the SPA in the E3 mode as follows:
Router(config)# card type E3 5 0
Router(config)# controller E3 5/0/0
Create an E3 ATM interface as follows:
Router(config-controller)# atm
Create a CEM group as follows:
Router(config-controller)# cem-group 0 unframed
Sample Configurations of the 2-Port Channelized T3/E3 CEoP SPA in the CT3-T1 Channelization Mode
Configure the SPA in the T3 mode as follows:
Router(config)# card type T3 5 0
Router(config)# controller T3 5/0/0
Create an NxDS0 T1 CEM group as follows:
Router(config-controller)# t1 2 cem-group 0 timeslots 1-12
Sample Configurations of the 2-Port Channelized T3/E3 CEoP SPA in the CT3-E1 Channelization Mode
Configure the SPA in the T3 mode as follows:
Router(config)# card type T3 5 0
Router(config)# controller T3 5/0/0
Change the channelization to the E1 mode as follows:
Router(config)# controller T3 5/0/0
router(config-controller)# channelized mode e1
Create an NxDS0 E1 CEM group as follows:
Router(config-controller)# e1 2 cem-group 0 timeslots 1-12
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 481
Configuring the Circuit Emulation over Packet Shared Port Adapter
Configuring Port Usage: An Overview
To Next Page
Loading...
Need help?
General
