Cisco ASR 1000 Series Software Configuration Guide

SUMMARY STEPS
1.
configure terminal
2.
controller wanphy interface-path-id
3.
wanphy report-alarm default
4.
wanphy report-alarm line
5.
wanphy report-alarm path
6.
wanphy report-alarm section
7.
wanphy report-alarm wis
8.
exit
9.
exit
10.
show controllers wanphy <interface-path-id>
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Router# configure terminal
Step 1
Enters the controller mode of the WAN-PHY SPA
installed in slot 2 of SIP 2.
controller wanphy interface-path-id
Example:
Router(config)# controller wanphy 2/2/0
Step 2
Sets the default alarm reporting values to SF,
SWLOF, B1-TCA, B2-TCA, PLOP, and WLOS.
wanphy report-alarm default
Example:
Router(config-controller)# wanphy report-alarm default
Step 3
Configures selective reports (LAIS, LRDI, SF, SD)
for line-level alarms.
wanphy report-alarm line
Example:
Router(config-controller)# wanphy report-alarm line
Step 4
Configures selective reports for path-level (PAIS,
PLOP, PPLM) alarms.
wanphy report-alarm path
Example:
Router(config-controller)# wanphy report-alarm path
Step 5
Configures selective reports for section-level
(SLOF,SLOS, SER, SWLOF) alarms.
wanphy report-alarm section
Example:
Router(config-controller)# wanphy report-alarm section
Step 6
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
162 OL-14127-17
Configuring the Ethernet SPAs
Configuring Alarm Reporting

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English