Cisco ASR 1000 Series

PurposeCommand or Action
Example:
TenGigabitEthernet0/1/0
Example:
Mode of Operation: LAN Mode
Enters the global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Configures WAN-PHY mode for the 1-Port
10-Gigabit Ethernet LAN/WAN PHY SPA.
hw-module subslot slot/subslot enable WAN
Example:
Router(config)# hw-module subslot 0/1 enable WAN
Step 3
When operation-mode is changed from
LAN to WAN, alarm messages are
displayed in the hw-module subslot
slot/subslot enable WAN command
output. But, if the operation mode is
changed from WAN to LAN, a
soft-reload of SPA occurs but alarms
are not displayed.
Tip
Example:
*Jan 7 03:49:25.778: %ASR1000_OIR-6-SYNCSPA: SPA
(SPA-1X10GE-WL-V2) reloading to come up in WAN mode
Example:
*Jan 7 03:49:25.978: %SONET-4-ALARM: TenGigabitEthernet0/1/0:
SLOF cleared
Example:
*Jan 7 03:49:25.979: %ASR1000_OIR-6-SOFT_RELOADSPA:
SPA(SPA-1X10GE-WL-V2) reloaded on subslot 0/1
Example:
*Jan 7 03:49:25.980: %SPA_OIR-6-OFFLINECARD: SPA
(SPA-1X10GE-WL-V2) offline in subslot 0/1
Example:
*Jan 7 03:49:34.117: %SONET-4-ALARM: TenGigabitEthernet0/1/0:
WLOS declared
Example:
*Jan 7 03:49:34.278: %SPA_OIR-6-ONLINECARD: SPA
(SPA-1X10GE-WL-V2) online in subslot 0/1
Example:
*Jan 7 03:49:34.826: %SONET-4-ALARM: TenGigabitEthernet0/1/0:
WLOS cleared
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 155
Configuring the Ethernet SPAs
Configuring the WAN-PHY Mode