EasyManuals Logo
Home>Cisco>Network Router>ASR 1000 Series

Cisco ASR 1000 Series Software Configuration Guide

Cisco ASR 1000 Series
602 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
If you are planning to remove a SIP along with its SPAs, then you do not need to follow the instructions in
this section. To remove a SIP, see the Preparing for Online Removal of a SIP, on page 39.
Deactivating a SPA
Although graceful deactivation of a SPA is preferred using the hw-module subslot stop command in EXEC
mode, the Cisco Aggregation Services Router 1000 Series support removal of the SPA without deactivating
it first. Before deactivating a SPA, ensure that the SIP is seated securely into the slot before pulling out the
SPA itself.
If you are preparing for an OIR of a SPA, it is not necessary to independently shut down each of the
interfaces prior to deactivation of the SPA. The hw-module subslot stop command in global configuration
mode automatically stops traffic on the interfaces and deactivates them along with the SPA in preparation
for OIR. In similar fashion, you do not need to independently restart any interfaces on a SPA after OIR
of a SPA or SIP.
Note
Choosing the Mode of the hw-module subslot Command
You can deactivate a SPA and all of its interfaces by using the hw-module subslot command in one of two
modes:
•
If you choose to use the hw-module subslot shutdown command in global configuration mode, you
change the configuration so that no matter how many times the router is rebooted, the SPA will not boot.
This command is useful when you need to shut down a SPA in a remote location and ensure that it does
not come back up if the router is rebooted.
•
If you choose to use the hw-module subslot stop command in global configuration mode, you cause the
SPA to gracefully shut down. However, the SPA will come up again when executing the hw-module
subslot start command.
To deactivate a SPA and all of its interfaces prior to removal of the SPA, use the following commands in
global configuration mode:
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
42 OL-14127-17
Troubleshooting the SIP
Preparing for Online Removal of a SPA

Table of Contents

Other manuals for Cisco ASR 1000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 1000 Series and is the answer not in the manual?

Cisco ASR 1000 Series Specifications

General IconGeneral
BrandCisco
ModelASR 1000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals